Jump to content

Moto Zajednica

Powertuning box

Recommended Posts

  • Svrati ponekad, 232 postova
  • Lokacija: Pecinci

 

 

 

 

 

Evo uputstva...

 

 

1.Locate IAT (Intake Air Temperature sensor).It is usually  on AIR BOX CLEANER ,throttle body,or somewhere near throttle body(see picture) ,under the fuel tank.It is two peen connector.

If you are not sure that you locate right,you can tested (see picture)

 

2.INSTALL CHIP

 

when you locate IAT,disconnect battery,ignition turn off

Then unplug two wire connector and plug chip in instead of IAT sensor

Once installed tie back or fasten the wires in a safe place (tape, silicone)

Reconnect the battery.

  Start the motor and hold at 2700 rpm's for 1 (one) minute. This will allow

the computer to re-program your ECU.

  After holding at 2700 rpm's, let the  bike idle for at least 15-20 minutes;

then turn bike off and restart before driving.

 

3. ENJOY THE RIDE

 

CHEERS

powertuning.2009

 

 

 

 

Podeli ovaj odgovor sa prijateljima


Link to post
Share on other sites

Pridruži nam se!

Možeš sada da napišeš svoj odgovor, a kasnije da se registruješ. Ako imaš nalog, uloguj se i napiši svoj odgovor.

Gost
Odgovori na ovu temu...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Aktivni korisnici   0 članova

    • Nema ulogovanih članova koji gledaju ovu stranu.


×
×
  • Create New...

Važno obaveštenje

Nastavkom korišćenja ovog sajta prihvatate Pravila korišćenja